Ruud Air Conditioner Prices

You have checked it all out and find out that your blower motor for you hot air furnace isn’t more than willing to turn anymore. Now, how do you get that motor out of there and get a new one in it is place? The routine actually is not as difficult as it may look. Getting things detached is not all that bad if you recognise where to look and what to do.

The power goes to the motor, but the motor will not turn. The blower wheel spins freely, so you recognise that the motor is bad. Now let’s get to removing the blower from the furnace so that we may get the motor changed.

The covers are off and the power is off to the unit. The wires to the motor have been disconnected. Now you need to look for the screws that hold the blower in the unit. If you have an up flow unit you may have to stand on your head to see them. They are specifically in the top flange of the blower bracket, at the front edge of the blower. Sometimes you may have to remove a condensate trap or the box that holds the furnace module to get to the screws and unquestionably to remove the blower assembly.

Once you find the screws and remove them along with whatsoever else is in front of the blower you may then slide the blower assemblage out towards the front of the unit. Most blowers are sliding on a track of numerous type. They will just slide right to you as you pull them out. Getting them out is easy getting them to slide back in correctly is another story.

Once you have got rid of the assembly, mark the position of the motor wires so that you may position the new motor the same. Usually there are three screws that hold the motor bracket. Remove the screws and loosen the set screw in the blower wheel hub. Place the blower assemblage over something that will concede the motor to hang freely. By lightly tapping the shaft with a rubber hammer or piece of wood you may get the motor to drop out of the hub of the blower wheel. If the tapping does not work undertake to spray the shaft with a lubricant and turn it with a pliers or wrench. Be careful not to score the shaft as this will make it hard for the shaft to slide through the hub.

Once the old motor is out, you may then remove the motor bracket from the old motor and reinstall it on the new motor. Remount the motor to the blower and tighten the blower hub set screw so that the blower spins freely. Reinstall the blower assembly, hookup the motor wires, replace any other things that were got rid of and you must be ready to make heat again!

Always make sure that you have got rid of all power before starting your work. Wear gloves to protect your hands from the sharp metal edges of the blower assemblage pieces. Changing your blower motor may be done by most any do it yourself person, with a bit of patience. It is not a occupation you may hurry through. If you get frustrated, walk away for a bit. It is awful what happens when you cool down and try with a fresh get started again. Take your time, be careful, and be safe!

Ruud Air Conditioner Prices

Ruud Air Conditioner Prices Image

Ruud Air Conditioner Prices

Ruud Air Conditioner Prices Photo

Ruud Air Conditioner Prices

Ruud Air Conditioner Prices Picture

Ruud Air Conditioner Prices

Ruud Air Conditioner Prices Picture

This entry was posted in Ruud Air Conditioner and tagged , , , , , , . Bookmark the permalink.

Leave a Reply